|
Figure 1 IRD
(Decoder) Connection
Decoder Setup: Scientific Atlanta PowerVu (Model
9223)
1. Turn the LNB power switch located on the rear of the Decoder to
the 19V DC setting.
2. Connect a video cable from the Video Out connector on the rear of
the Decoder to the Video input on the rear of the TV monitor.
Connect audio cables from the L-R Audio Output connectors on the
rear of the Decoder to L-R Audio Input connectors on the rear of the
TV Monitor.
3. Connect the Decoder to the AC power source. A green dot will
appear in the center of the front panel display window. Push the
on/off switch, located on the front lower left of the Decoder, to
turn the Decoder on. Select Channel 0.
4. On the front panel keypad, press MENU.
5. Press 2, to unlock the installer MENU.
6. Press 9 to bring up the first page of the installer MENU.
NOTE: The INSTALLER MENU consists of two pages of selectable
settings for transponder frequency and other vital decoder specific
parameters including a preset frequency plan. You can exit this menu
at any time by pressing VIEW.
7. Press CHAN UP/DN on the front left portion of the Decoder to
change the setting to appropriate setting for your satellite region.
8. Press NEXT on the front keypad to select L/C-band Freq setting on
the menu screen. Using the keypad enter the correct L/C-band
frequency setting for your satellite region.
9. Scroll to the Polarization block, push the SELECT button to enter
H (fixed).
10. Press NEXT to move the arrow down to the FEC RATE. Using the
channel up/down keys enter the correct FEC RATE for your satellite
region. SatNet users should select ¾ and DTS users should select
2/3.
11. Press NEXT to select SYMBOL RATE. Using the keypad enter the
correct SYMBOL RATE for your satellite region.
12. Press YES on the front keypad section and note the system will
respond that it is saving the entries in the upper right of the TV
monitor. NOTE: Failure to save entries will result in the system
reverting to the factory default settings and the Decoder will not
authorize.
13. Double check the changes you made to page 1 of the installer
MENU comparing the settings with those listed in the PowerVu setup
data for your satellite region.
14. Press USER to select page 2.
15. Press NEXT to select NETWORK ID.
16. Using the keypad enter the NETWORK ID for your satellite region.
17. Press YES to save the changes.
Return to our AFN Antenna
and Decoder Setup Guide (Step 2) |
